Table of Contents
Advertisement
Release the System from Docking Cart (continued)
Switch the Three Probes
NOTE:
System Operation
NOTE:
NOTE:
NOTE:
LOGIQ e – Basic Service Manual
5461614-100 English Rev. 6
1. Disconnect the probe connector of Three-Probe Port from
the system.
2. Rotate the handle to unlock system
3. Place palm of one hand on the handle and push the system
release button toward you with the other hand until it stops,
then release the button back to it's normal position.
4. Lift up the system from the platform.
The system can switch the probe between the three probe which
are connected in the Docking Cart Three Probes Box.
From the keyboard, press the Exam key. The Probe screen
appears. Select the probe which you want.
Figure 11-18. Probe Screen
If the docking cart loses power, the factory default probe is the
probe which is connected to the port.
LOGIQ e is supported on Docking Cart.
To upgrade the system, release the system from the Docking
Cart and connect the USB Memory Stick or SD Card to the
system directly.
To power off Docking Cart, open the circuit breaker and then
pull out the AC Power Cord from the wall AC outlet.
Do not plug the AC Power into the wall in the state of closing the
circuit breaker.
Cart Using
11-43
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the LOGIQ e and is the answer not in the manual?
Questions and answers
Need to do backup to remove ultrasound results off LOGIQ e system
To back up ultrasound results from the GE LOGIQ e system:
1. Insert a backup storage device (DVD-R disk, USB memory device, or SD Card).
2. Navigate to Utility -> System -> Backup/Restore.
3. Select the item to back up.
4. Enter or browse to the backup destination.
5. Select Backup.
6. The backup status for each item will be displayed in the Result column.
This answer is automatically generated