Heat Charm Port Phillip 600 Series Installation & Operating Instruction
  1. Manuals
  2. Brands
  3. Heat Charm Manuals
  4. Stove
  5. Port Phillip 600 Series
  6. Installation & operating instruction

Heat Charm Port Phillip 600 Series Installation & Operating Instruction

Hide thumbs Also See for Port Phillip 600 Series:

Advertisement

Table of Contents

OPERATING INSTRUCTIONS
Serial Number of Heater: ____________ Model: ___________________
H
C
EAT
Revised: 29/10/2020
Port Phillip 600 Series
INSTALLATION
HARM WOODHEATERS ARE AUSTRALIAN OWNED AND
MANUFACTURED BY
SHAMIC SHEETMETAL
SHAMIC SHEETMETAL
SHAMIC SHEETMETAL
SHAMIC SHEETMETAL
PO BOX 8, KILSYTH, VIC. 3136
PH: 03 9737 5300
https://shamic.com
&
(AUST.) PTY. LTD.
1
Printed: 13/11/2020

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Port Phillip 600 Series and is the answer not in the manual?

Questions and answers

Related Manuals for Heat Charm Port Phillip 600 Series

Summary of Contents for Heat Charm Port Phillip 600 Series

  • Page 1 Port Phillip 600 Series INSTALLATION & OPERATING INSTRUCTIONS Serial Number of Heater: ____________ Model: ___________________ HARM WOODHEATERS ARE AUSTRALIAN OWNED AND MANUFACTURED BY SHAMIC SHEETMETAL SHAMIC SHEETMETAL SHAMIC SHEETMETAL SHAMIC SHEETMETAL (AUST.) PTY. LTD. PO BOX 8, KILSYTH, VIC. 3136 PH: 03 9737 5300 https://shamic.com...
  • Page 2 SAVE THESE INSTRUCTIONS INSTALLATION AND OPERATION INSTRUCTIONS Have your heater installed by a registered or licensed installer and advise your insurers for inclusion in your household contents policy. In some states the installer is required to issue a certificate of compliance on the installation; - ensure you obtain this if applicable! The heater should be checked for scratches/dents prior to installation.
  • Page 3 INSTALLATION INSTRUCTIONS (FREESTANDING MODELS ONLY) Select the position of your heater carefully, taking into consideration all combustible materials in the roof; eg. ceiling joists, roof trusses, etc. Determine flue location through the ceiling: Position the hearth correctly (see below), then place the heater on the hearth so that the flue spigot on the heater is correctly aligned with the flue location from the ceiling.
  • Page 4 INSTALLATION OF FIRE PLACE INSERT MODELS ONLY The heater must only be installed in either a sound concrete or masonry fireplace, connected to a chimney, both of which must be inspected for soundness and thoroughly cleaned before the heater is Shamic Shamic Shamic...
  • Page 5 Firebox Internal Set Up Step 1. Install the top baffle plate, place both hands underneath the plate lift either the right or left hand side of the plate up so it is on an angle. Lift up over the locating tab on the side of the firebox then lift up the other side and push the plate to the back of the firebox.

  • Page 6: First Fire

    FIRST FIRE YOUR HEATER HAS BEEN SPRAYED WITH HIGH TEMPERATURE PAINT. TO ENSURE THAT THE PAINT IS PROPERLY “CURED IN”, PLEASE FOLLOW THESE STEPS WHEN LIGHTING THE FIRST FIRE IN THE HEATER: • ENSURE THE AIR CONTROL SLIDE IS FULLY OPEN. •...

  • Page 7: Operating Information

    Operating Information Fuel Ignition: A supply of firelighters or newspapers. Kindling: 10 mm – 20 mm diameter light, split, pieces of dry wood. Start up wood: 30 mm – 75 mm diameter medium size, split pieces of dry wood. “BURN ONLY HARDWOOD” Starting a fire Fully open the air slide, lift the door handle upward and open the door slowly.
  • Page 8 Use of the fan Heatcharm heaters are fitted with a 3-speed fan for efficient distribution of warmth. Operating the fan in your wood heater is critical at all stages of use except at startup, where the follow steps apply: • When the fire has been underway for 30 minutes turn the fan on to low •...

  • Page 9: Replacement Parts

    Do not slam the door closed Wood may be protruding from the firebox and cause the glass to break. It will also diminish the longevity of the door seal. Preparing for a low (overnight) burn For an extended low burn ensure a maximum fuel load is placed into the heater, following the reloading procedure outlined previously.

  • Page 10: Door Glass

    Maintenance Paint surfaces After the curing process has taken place, little maintenance is required other than dusting off with a cotton cloth. Most marks can be buffed out with a cotton cloth without the need for retouching. NOTE: Do not use abrasive cleaners or harsh solvents (such as methylated spirits). Should you experience scuffing or scratching, or discolouration due to incomplete curing, the high temperature paint can be touched up and matching spray cans may be purchased from your Heatcharm dealer.

  • Page 11: Door Adjustment

    Door Adjustment The door is unlikely to become misaligned unless it is knocked and attempts at adjustment may cause rather than solve a problem. Always consult your Heatcharm dealer before attempting any adjustment to the door. 1. Remove door by opening fully and lifting door up off the hinge. (Freestanding models require top panel to be propped up prior to lifting door).
  • Page 12 At the end of the heater season you should clean and vacuum the fan and fan tray. Dust and hair can accumulate, especially if you have a pet. Turn the mains power off and disconnect the power lead from the wall socket. Console Model 1.
  • Page 13 Baffle plate removal The baffle plate is held in place with four locating tabs – 2 either side, front and rear of the firebox. WARNING: ALLOW THE HEATER TO COOL IF HOT BEFORE ATTEMPTING BAFFLE PLATE REMOVAL. Steel Baffle 1. Lift the front of the baffle up and pull forward over the supports until the baffle clears the locating slots in the back wall of the firebox.
  • Page 14 TABLE 1: FIREWOOD SPECIES AND THEIR PROPERTIES Firewood Forest Type Heat Density Splitting Ignitability Coals Sparks Avail. Species Avail. (Dry Air) Per Unit Ib/ft3/ Volume Kg/m3 Mallee Roots Mallee Difficult Poor Excellent Good Belah, Buloke Mallee 70 / Good Poor Excellent Limited Box-Ironbark...

  • Page 15: How To Make A Warranty Claim

    How to Make a Warranty Claim Coonara, Heatcharm and Arrow Heaters. The full Warranty Statement for your heater is contained in the Installation and Operating Instructions booklet that was provided with the product. 1. Check the details of the warranty statement 2.
  • Page 16 Revised: 29/10/2020 Printed: 13/11/2020...
  • Page 17 HEATCHARM WOODHEATERS WARRANTY – CONSOLE & INBUILT MODELS DESIGNATION OF WARRANTOR. This warranty is extended by Shamic Sheetmetal (Aust) Pty. Ltd with respect to Heatcharm Wooheaters PRODUCT. This Heatcharm heater is comprised of the heater proper (including components and firebox), fan assembly, speed control switch, electrical components, firebricks, seals and moving parts.

This manual is also suitable for:

Port phillip i600Port phillip c 600

Table of Contents