Table of Contents
Advertisement
Confidential
9. Insert the FD you made at step 3 into the floppy disk drive. Then select [TMUSB90.inf].
10. When the message [Search for driver files for the following hardware device. EPSON USB
Controller for TM Printer Series. Windows is now ready to install the best for this device?.] appears
as shown in Figure 3-1, click Next. Then click Finish in the next window.
11. While the printer is on, open the device manager. If the [EPSON USB Controller for TM
Printer Series] exists on the Universal Serial BUS controllers, the installation is successful.
12. Start the OPOS ADK; then click Add for the device. Select the printer that has "U" after its
name.
13. Open [Check Health Interactive] and start the test printing. When the test printing is
completed properly, the installation is finished.
Installing Advanced Printer Driver
1. First, prepare a blank FD. Start the steps below while the TM printer and PC are not
connected.
2. Start the Advanced Printer Driver installer (ADT***J.exe), and follow the instructions on
Wizard.
3. The device driver [TMUSB90.SYS] and [TMUSB90.INF] are saved in the folder in which
Advanced Printer Driver is installed. Save them to the FD.
4. Connect the printer with UB-U90 attached to PC while the printer is off.
5. Turn on the printer. Installation starts by Plug and Play feature.
6. When you see the message [This wizard searches for new drivers for], click Next.
7. [What do you want Windows to do?] appears. Then select [Search for the best driver for your
device. (Recommended)] option and click Next.
3-2 Software
Figure 3-1
Rev. B
Advertisement
Table of Contents
