Customer Display Connection Setting; Tm Printer With No Dm-D Connector; Tm Printer With A Dm-D Connector - Epson UB-S09 Developer's Manual

Serial interface board

Hide thumbs Also See for UB-S09:

Table of Contents

Confidential

Customer Display Connection Setting

There are two types of TM printers: One type has a DM-D connector (a connector for the

customer display) and the other type does not have a DM-D connector. The customer display

settings for each type are as follows:

The cable for the customer display is connected to the DM-D connector on the UB-S09 and the

customer display connection is set using the jumpers on the UB-S09.

Table 2-3 Customer display connection settings and operations 1

UB-S09 connector

DM-D not connected

(JP1: 2-3 shorted)

DM-D connected

(JP1: 1-2 shorted)

Note: • DM-D connection is selected from JP1; however if no DM-D is actually connected to the connector of the

UB-S09, the RTS signal will always be BUSY.

• Operations are based on these JP1 settings even if the DM-D is not actually connected.

The customer display cable can be connected to either the connector on the UB-S09 or on the TM

printer; however, it is recommended to connect the cable to the connector on the TM printer.

The TM printer must be set to enable the DM-D connection by the DIP switch on the TM printer.

(For details, refer to the DIP switch section in the specification of each TM printer.)

2-4 Installation

Operation

• ESC= default of TM printer: Printer select

• Self test print: No DM-D settings print

• GS I: No DM-D DIP switch status function

• RTS signal: No DM-D status output

• ESC= default of TM printer: Printer select

• Self test print: No DM-D settings print

• GS I: No DM-D DIP switch status function

• RTS signal: DM-D status output from UB-S09 connector

Rev. B

Table of Contents