Advertisement
step 6: Attach the two upper braces on each sides of the gauge and lever
assembly using hex bolt M6x45 and nylon lock nut M6. Loosely tighten.
Connect the other four ends of the braces to the upper mounting tube using
bolt M6x45 and nylon lock nut M6. Tighten all fasteners.
step 7: 1. Align all the six holes around inside of hopper and frame and
attach using bolts M6x50, big flat washer Ø6 on the top and secure with
nylon lock nuts m6 on the bottom. Adjust parts the so the impeller moves
freely and tighten the hardware holding the hopper. 2. Insert the R pin
Ø3x75 into the hole on the swivel axle.
Hopper needs to go
over the shaft
step 8: Install one flat washer Ø8 on the end of the connection rod and insert into the hole on the rod base and secure using a nylon lock nut
m8.
© Jack Sealey Limited
Original Language Version
step7
step8
SPB80T.V2 | Issue:1 11/11/19
step6
Ensure rod is
laying on top
Advertisement
