Advertisement
Premium 10501
P10501A07.DOC
1.4 LUBRICATING INSTRUCTIONS CD-PRO 2
Introduction
These instructions provide some maintenance information in order to keep the CD-Pro 2 in optimal
condition. Although operating the CD-Pro-2 under normal conditions will keep the need for
maintenance to a minimum.
In case of operating the unit in more polluted environments, with e.q. dust and smoke, maintenance
may improve the proper working of the unit.
Prior to any maintenance activity the instructions should be followed with care.
Refer further to the general maintenance instructions (Chapter 7) and ESD measures
(Chapter 2 of the product specification) in this starter kit
Instructions
•
Excessive greasing must be avoided in order to prevent contamination of optical parts.
•
Wipe all exposed lubrication points and remove all old grease and dirt by a cotton swab.
To insure proper operation, check no cotton remains on gears and sledge guidance.
•
Always move the sledge by spinning the sledge motor worm gear with finger.
To avoid damaging the gear rack and gears never move the entire sledge by hand.
1.4.1 Removal top cover.
Philips components
draft
Removal of black plastic cover (4 screws)
Using a Torx screwdriver No 6.
The OPU spindle is now accessible from the topside
© 2000 Philips Electronics N.V. All rights reserved
Maintenance instruction Premium 10501
Figure 1
11-07-2000
Page 9
Advertisement
