Advertisement
Premium 10501
P10501A07.DOC
1.4.2. Removal of Pcb from the Mechanism.
1.4.3. E.S.D Measures
Philips components
draft
Remove the Pcb by releasing the flex foil from the connector
after unscrewing the four pcb fixing screws.
Lift the small ears on each side of the flex connectors with e.g.
a small screw driver and take out the flex foil.
Make sure during (re) mounting of the flex foil that the
flex foil is inserted straight and the connector is properly closed.
Take proper E.S.D. precautions when the Pcb is separated from
the mechanism.
Provide a short circuit clip or a paperclip to the leads of the
OPU flex foil in order to protect the laser and electrical circuitry
against E.S.D.
© 2000 Philips Electronics N.V. All rights reserved
Maintenance instruction Premium 10501
Figure 2
Figure 3
11-07-2000
Page 10
Advertisement
