Konica Minolta REGIUS 110 Service Manual page 176

Chapter 5 Disassembly and Assembly
A
8
See the descriptions following
install the receiver belt.
Now, you have finished with the procedures to replace the receiver (receiver unit assembly).
5-56
5
Replace the parts.
6
Install the receiver.
•
Press the receiver in the direction of the arrow shown
in the figure to secure it to the guide on the slide pack.
7
Connect the connector (JP17), that was removed
in
cable to the guide with the
JP17
B
First Front Side
Step 7 in "5.4.12 Replacing the Receiver Belt (Page 5-59)"
If the cable has been unplugged, align the
white mark of the cable with the Hole A
Important
shown in the figure, then bind the cable with
the wiring band to fix.
4 screws (M4 x 6)
Step 2, to the original position to secure the
wiring band
Make sure that no twisted part is found in
the cable, then align the white mark of it with
Important
the fixing position (B in the figure) to fix it.
.
to