[Note on assembly] (DP-V1711)
1. When replacing ①, change ③, and peel off the「LABEL, SERIAL」attached to ① before replacement, then attach it to
the new part in the same position as it was on ① before replacement.
Note: There is no need to replace ②
Top & Side:
Leave a margin of
Leave a margin of
approx. 5mm at
both top & side
when attaching.
LABEL, SERIAL
Side: Leave a margin of 1-2mm.
Side: Leave a margin of 1 2mm.
Mark
Parts No.
①
DL1-0141-000
②
DD1-0368-000
③
DD1-0652-000
GASKET, as it is not used inside of ①.
①
Description
COVER, REAR
GASKET, EMI FOR SDI
LABEL, CAUTION
Page 14
③
Top: Attach so that one
Qty
row of air holes are
covered.
1
0
1