Key Combinations - Special Functions; Displaying The Feeder Inching Speed - Fronius TransSynergic 4000 Operating Instructions Manual

No.
(21)
(22)
(23)
(24)
(25)
(26)
Key combina- The following special functions can be called by pressing buttons simultaneously or
tions - special repeatedly.
functions
Displaying the
feeder inching
speed
Toowoomba Welding Supplies : tweld.com.au : Ph +61 7 4659 0044
Function
Mode button
for selecting the mode
2-step mode
4-step mode
Special 4-step mode (aluminium welding start-up)
Spot welding mode
Operating mode
When a mode is selected, the LED behind the relevant symbol lights up.
Material button
for selecting the filler metal and shielding gas to be used. Parameters SP1 and
SP2 are reserved for additional materials.
When a material is selected, the LED behind the relevant filler metal lights up.
Diameter / Index (wire diameter) button
for selecting the diameter of the wire to be used. Parameter SP is reserved for
additional wire diameters.
When a wire diameter is selected, the LED behind the relevant wire diameter
lights up.
Intermediate arc indicator
a spatter-prone intermediate arc occurs between the short arc and the spray
arc. The intermediate arc indicator lights up to alert you to this critical area
Store button
for opening the Setup menu
Purge (Gas test) button
for setting the required gas flow rate on the pressure regulator.
Gas will flow out for 30 s after pressing the gas test button. Press the button
again to stop the gas test flow before the end of this period.
The set feeder inching speed is shown
(e.g.: Fdi | 10 m/min or Fdi | 393.70 ipm).
Use the adjusting dial to change the feeder inching speed
Press the Store button to exit.
47