mspa DELIGHT BUBBLE Spa After-Sales Service Manual page 36

Temperature sensor failure
Water level
minimum water line
Water inlet is
E1
Filter failure
No filtering water from the inlet
Flow switch
Memory self - check after
power on
Signal cord gets loosen
EEP/888/BBB
Power boards failure
Power failure
PRCD is off
No display on
the control
panel
PRCD is
Signal cord gets loosen
Spa inlet connection not
securely
Drainage valve is
screwed on
Spa leaking
Water leaks from the spa pool
body
Low water level
Temperature is set too low.
No heating
Dirty filter cartridge
properly
Heating element failure (Not
heating up)
Visit our website at: www.the-mspa.com
Replace with a new temperature sensor
doesn't reach the
Add more water to the minimum line.
Replace with a new filter and clean the inlet.
blocked
Video guide: https://youtu.be/4-jyyfKg9xM
No filtering water from the inlet, take out the control box (heater/blower
engine) to the local service partner, a new filter pump needs to be
replaced.
Video guide: https://youtu.be/ZyibpFOkGvU
Check whether there is abnormal objects blocked the flow swich, clean
is not closed it or change a new flow switch.
Video guide to take out the control box: https://youtu.be/ZyibpFOkGvU
Power off the plug. Wait
yes, re-start the power to use the spa as normal.
Uncsrew the control panel and tighten the singal cord
Take out the control box (heater/blower engine) to the local service
partner, a new power board in the control box needs to be replaced.
Video guide: https://youtu.be/ZyibpFOkGvU
Check the power supply
Reset the PRCD following testing guidelines (press the RESET / TEST
/ RESET in sequence)
defective Replace with a new PRCD
Uncsrew the control panel and tighten the singal cord
Tighten the inlet&outlet connection.
tight(if not fixed tight).
not well
Close the drainage valve.
Re-glue help
body:https://youtu.be/szF-4t0Ff5Q
Add more water to the minimum line.
Set a higher temperature
Clean or replace a new filter cartridge
Take out the control box (heater/blower engine) to the local service
partner, a new heater in the control box needs to be replaced.
Video guide: https://youtu.be/ZyibpFOkGvU
2019-2020
for
or contact service partner to replace a new pool
- 36 -
Delight Service Manual
5S to see if the error code will disappear. If