Connect Your Solo To Wi-Fi - POD Point Solo Smart Charger Connection Manual

Connect your Solo to Wi-Fi

Solo Smart Charger status light
Once the Solo Smart Charger is turned on, the
status light on the front will illuminate white.
Note: Please have your Wi-Fi password ready and complete these steps whilst near to your Solo.
1
Turn the Solo off and on at
the switch on the fuse box/
consumer unit.
Scan for podpoint Wi-Fi
network on a mobile device
and press connect.
For Android device users:
Press YES on the pop-up message.
03
2
Open your web browser and type
in the following:
192.168.1.1
3
Pick your home Wi-Fi
network from the list and
type the password.
Press Connect.
Note: Please pair the Solo to 2.4
GHz Wi-Fi networks only.
Pod Point Home Unit Wi-Fi
Connect your Pod Point Home Unit to Wi-Fi by selecting a
network and entering the password.
My Home Wi-Fi
Guest Wi-Fi
The Smiths
Pod Central
4
The new settings will take
15-30 minutes to activate. You can
activate them immediately if you
switch your charger off and on
again. The Solo's status light should
go blue with a short pink flash
every few seconds.
If the status light remains white,
you may need to restart the Solo
again and verify the settings. If
the connection is still unsuccessful,
retry the process with a different
device. If this still isn't working,
contact support.
04