Xrt And Deployment Shell Installation Procedures On Ubuntu - Xilinx Alveo U200 Getting Started Manual

11. You will be asked to confirm the update, as shown below. Type y and enter.
Probing card[0]: DSA on FPGA needs updating
DSA on below boards will be updated:
Card [0]
Are you sure you wish to proceed? [y/n]
Flashing will take up to 10 minutes. Successfully flashing a new card results in a message
similar to the one shown below. If you do not see one, refer to
Updating DSA on card[0]
INFO: ***Found 880 ELA Records
Idcode byte[0] ff
Idcode byte[1] 20
Idcode byte[2] bb
Idcode byte[3] 21
Idcode byte[4] 10
Enabled bitstream guard. Bitstream will not be loaded until flashing is
finished.
Erasing flash............................................
Programming flash............................................
Cleared bitstream guard. Bitstream now active.
1 Card(s) flashed succesfully
Cold reboot machine to load the new image on FPGA
If you have previously upgraded the card, you will see a message similar to the following:
Probing card[0]: DSA on FPGA is up-to-date
0 Card(s) flashed successfully.
12. Cold boot your machine to load the new firmware image on the FPGA.
IMPORTANT! Be sure to fully power off the machine and then power it on again. The image will not
boot from flash if the machine is only rebooted.
IMPORTANT! Assurez-vous d'éteindre complètement la machine, puis de la rallumer. L'image flash ne
démarrera pas si la machine n'est pas redémarrée.
Wichtig! Schalten Sie das Gerät vollständig aus und wieder ein. Das Image startet nicht von Flash,
wenn der Computer nur neu gestartet wird.
The installation for deployment is now complete. You can go directly to
and Validation to validate the installation.
XRT and Deployment Shell Installation
Procedures on Ubuntu
Use the following steps to download and install the software using an RPM installation package.
For details on upgrading or downgrading the XRT and deployment shell, see
Downgrading, and Uninstalling XRT and Deployment Shell on
UG1301 (v1.3) February 12, 2019
Getting Started with Alveo Accelerator Cards
Chapter 4: Installing the Deployment Software
Chapter 7:
Chapter 5: Card Bring-Up
Ubuntu.
Send Feedback
Troubleshooting.
Upgrading,
www.xilinx.com
23