Honeywell ScanPal EDA71 User Manual page 43

Setting
Scan delay
Decode Timeout
Trigger Scan
Mode
Same symbol
timeout
Notification Settings
Use the Notification Settings to configure how your tablet responds when you scan
a barcode.
Notification Settings
Setting
Good Read Notification
Bad Read Notification
Vibrate On Notification
Add a Scan Setting Profile
To create a scan setting profile for a custom app on the tablet:
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Settings
3. Tap
4. Take one of the following actions:
EDA71 User Guide
Description
Set the minimum amount of time in seconds before the scanner
can read another barcode.
Set the number of seconds before the scanner automatically turns
off if the scan button is pressed and nothing has successfully
decoded.
Set read behavior on scan button press. Options available:
•
•
•
•
Set the minimum buffer time in seconds before the scanner reads
the same barcode. This can be adjusted to prevent inadvertent
scans of the same barcode if the code is left in the scan field longer
than the Decode Timeout limit. The default same symbol timeout is
1000 seconds.
> Honeywell Settings > Scanning > Internal Scanner.
in the upper right corner of the app screen.
• Tap the profile name field, and then add a new name.
OR
• Tap the select an application option, and then choose an app from the list.
One Shot
Continuous
Read on release
Read on second trigger press
Description
Enables or disables a good read notification. The
notification consists of a green blink of the Scan Status
LED, a short beep, and an optional short vibration.
Enables or disables notification of a failed scan. The
notification consists of a red blink of the Scan Status LED,
an error beep, and an optional short vibration.
Enables or disables whether the tablet vibrates when there
is a good or bad read.
Default
0
20
One
Shot
Disabled
Default
Enabled
Disabled
Disabled
33