Honeywell ScanPal EDA71 User Manual page 14

Warning: Improper use of the battery in this device can cause fire or
Warning: Do not store the battery without using for a long period of time.
Battery Part Numbers
Warning: Read
Battery Model
Number
BAT-EDA50
EDA70-EXT
Charge the Battery Before Use
Before using EDA71, you need to make sure the battery (model number: BAT-
EDA50) is fully charged. You can charge the battery before or after installing it to
EDA71. It will take about 5 hours for the battery to be fully charged using original
charger, quad bay charger, or single cradle charger.
Note: Honeywell recommends recommend using Honeywell's original charger; any
damage caused by use of non-Honeywell charger is not covered by warranty.
Warning: Ensure all components are dry prior to mating the tablets and
Note: Using the tablet while charging the battery increases the time required to reach a full
charge.
4
chemical burns. Please do not disassemble the battery or heat
it to 100°C (212°F) and above, or incinerate the battery. Make
sure waste batteries are properly disposed. Keep out of reach
of children.
If storing the battery for over 3 months, please make sure to
check the remaining battery power capacity is at least 30%
every 3 months.
Battery Recommendations and Safety Protections
cautionary markings on the battery, charging peripheral, and
device using the battery before attempting to install, use, or
charge the battery.
Battery Part Numbers
50129589-001
50134176-001 (For use in North America)
50141821-001
batteries with peripheral devices. Mating wet components may
cause damage not covered by the warranty.
and all
EDA71 User Guide