Z-Wave Settings; Reset Controller - 2gig Technologies EDGE Manual

1. On the Installer Toolbox menu, tap Z-Wave
Settings.

Z-Wave Settings

Z-Wave Settings available from the Installer
Toolbox include:
»
View All Devices
»
Add Device
»
Remove Device
»
Check Network
»
Rediscover Network
»

Reset Controller

See Z-Wave Setup section, pg . 14, for setup
instructions for these options .
Reset Controller
Available only for Installers, the Reset Controller
option is also found on the Z-Wave settings menu.
Reset the panel's Z-Wave Controller back to default
settings.
1. Tap Reset Controller.
2. Tap Yes to start the process.
NOTE: Once Yes is selected, the reset cannot be
reversed .
NOTE: If this controller is the Primary controller for
your network, resetting it will result in the nodes
in your network being orphaned and it will be
necessary after the reset to exclude and re-include
all of the nodes in the network .
If this controller is being used as a Secondary
controller in the network, use this procedure to
reset this controller only in the event that the
network Primary controller is missing or otherwise
inoperable .
23
Copyright © 2021 Nortek Security & Control LLC