Hitachi RCI Service Manual page 336

10 Servicing
C A U T I O N
Do not knock the front panel while removing it as this could
break the panel casing.
Start with the air outlet part when fitting the front panel. Then locate
the three hooks at the top of the front panel.
Open the front panel as described and secure the screw in the
centre of the panel.
Press the front attachment area and make sure there are no gaps
between the front panel and the unit casing.
After fitting the front panel, tighten the three screws at the bottom
of the air outlet and cover with the bushings.
N O T E
• There are three spacer stops inside the front panel.
• Gaps between the front panel and the unit casing may lead to air or condensate leaks.
Removal of the front panel (RPK -2.0FSN2M only)
Remove the right side cover to connect the gas refrigerant pipes and wiring and to check the drainage water flow.
C A U T I O N
Completely cover the front panel with a sheet of plastic to protect it during installation work.
Remove the three bushings and the screws.
Pull slowly on the bottom of the front panel, making sure the air
outlet does not touch the outlet grille.
324
SMGB0063 rev. 1 - 10/2010