Hitachi RCI Service Manual page 228

6 Optional functions
F6 – Automatic heating temperature release
This function is used to set automatic temperature release for the HEAT function.
Setting
19
20
21-24
25
26-28
29
30
F7 – Prevention of operation stoppage due to remote control operating error
F8 – Operation mode selection interlock
This function is used to prevent changes to the operating mode. The setting condition is shown below.
Setting
00
01
F9 – Temperature setting interlock
This function is used to prevent changes to the temperature setting. The setting condition is shown below.
Setting
00
01
FA – Fan speed selection interlock
This function is used to prevent changes to the fan speed. The setting condition is shown below.
Setting
00
01
Fb – Automatic louver interlock
This function is used to prevent changes to automatic louver operations. The setting condition is shown below:
Setting condition
00
01
FC – Lower cooling temperature setting limit
This function is useful to set the temperature range in cooling mode. It enables the cooling range to be reduced for
configuration using the remote control. The setting condition is shown below:
Setting
00
01
02
03-08
09
10
216
SMGB0063 rev. 1 - 10/2010
Condition setting
19 °C
20 °C
(21-24) °C
25 °C (factory setting)
(26-28) °C
29 °C
30 °C
Condition setting
Not available
Available (factory setting)
Contents
Not available
Available (factory setting)
Contents
Not available
Available
Contents
Not available
Available
Contents
Standard
Lower limit +1 °C
Lower limit +2 °C
Lower limit +(03-08) °C
Lower limit +9 °C
Lower limit +10 °C