Panasonic U-72MF1U9 Technical Data Manual page 51

4. Installation Instructions
4-10. Remove the Brackets Used for Transport
After installing the unit, remove the
2 transport brackets from the front
and rear (4 brackets total).
4-11. Routing the Tubing
The tubing can be routed out either from the front or from the bottom. (Fig. 2-17)
The connecting valve is contained inside the unit. Therefore, remove the front panel. (Fig. 2-17)
(1) If the tubing is routed out from the front, use cutting pliers or a similar tool to cut out the tubing outlet slit (part
indicated by ) from the tubing cover. (Figs. 2-17 and 2-18)
Tubing cover
Remove 2 screws
(2) If the tubing is routed out from the bottom, remove
the slit part ( ).
Use a drill bit approximately 13/64" dia. to create
holes at the 4 slit hole indentations (openings).
Punch out the slit part (
Be careful not to damage the base plate.
(Fig. 2-16)
Remove the 2 screws
(8 screws total)
Front
Bottom
Use cutting pliers or similar
tool to cut cover out
).
Fig. 2-16
Remove 11 panel
screws from front
panel
Fig. 2-17
Indentation
(4 locations)
2 - 37
Design of 3WAY VRF SYSTEM
Remove the 2 transport brackets from
the front and rear (4 brackets total)
Slit hole
Fig. 2-18
1
2
3
4
5
6
7
8