Table of Contents
Advertisement
Bosch Rexroth AG
Safety Instructions for Electric Drives and Controls
Bosch Rexroth is not liable for damages resulting from failure to observe the
●
safety instructions.
Read the operating, maintenance and safety instructions in your language be-
●
fore commissioning. If you find that you cannot completely understand the
application documentation in the available language, please ask your supplier
to clarify.
Proper and correct transport, storage, mounting and installation, as well as
●
care in operation and maintenance, are prerequisites for optimal and safe op-
eration of the component.
Only qualified persons may work with components of the electric drive and
●
control system or within its proximity.
Only use accessories and spare parts approved by Bosch Rexroth.
●
Follow the safety regulations and requirements of the country in which the
●
components of the electric drive and control system are operated.
Only use the components of the electric drive and control system in the man-
●
ner that is defined as appropriate. See chapter "Appropriate Use".
The ambient and operating conditions given in the available application docu-
●
mentation must be observed.
Applications for functional safety are only allowed if clearly and explicitly
●
specified in the application documentation "Integrated Safety Technology". If
this is not the case, they are excluded. Functional safety is a safety concept in
which measures of risk reduction for personal safety depend on electrical,
electronic or programmable control systems.
The information given in the application documentation with regard to the
●
use of the delivered components contains only examples of applications and
suggestions.
The machine and installation manufacturers must
– make sure that the delivered components are suited for their individual ap-
plication and check the information given in this application documenta-
tion with regard to the use of the components,
– make sure that their individual application complies with the applicable
safety regulations and standards and carry out the required measures,
modifications and complements.
Commissioning of the delivered components is only allowed once it is sure
●
that the machine or installation in which the components are installed com-
plies with the national regulations, safety specifications and standards of the
application.
Operation is only allowed if the national EMC regulations for the application
●
are met.
The instructions for installation in accordance with EMC requirements can be
●
found in the section on EMC in the respective application documentation.
The machine or installation manufacturer is responsible for compliance with
the limit values as prescribed in the national regulations.
6/35
PROFIBUS-DP Bus Adapter
DOK-RCON01-PROFIBUS***-IB04-EN-P
Advertisement
Table of Contents
