Setting MCU option
Rotary switch for Indoor unit ADDRESS
How to set up
Set the rotary switch located at outdoor unit PCB to match the number of connected indoor units (8).
Set the rotary switch located at outdoor unit PCB to match the number of connected MCU (2).
When installing more than 2 MCUs, set each rotary switch of MCU differently.
Set rotary switch located at MCU PCB to match indoor unit address.
Set the DIP switch of MCU to "OFF" position for the indoor units that is not connected.
MCU PCB
MCU address
Indoor unit
• Connect the power cable using the compressed ring terminal.
MCU
MCU
• Communication cables are connected as shown above when installing MCU.
• W hen installing electricity and wires of MCU, please proceed the work refering to the installation manual of the
HR outdoor unit.
DIP switch for indoor unit setting (ON:Use, OFF:Not use)
Setting the
number of
Indoor Unit
Indoor unit address
Indoor unit
Indoor unit
MCU
Indoor unit
Indoor unit
Indoor unit
MCU
Indoor unit
Rotary switch for MCU ADDRESS
Outdoor Unit
PCB
Setting the
number of
MCU
MCU PCB
MCU address
Indoor unit address
Indoor unit
Indoor unit
Indoor unit
Indoor unit
Indoor unit
Indoor unit
Indoor unit
21