Step-By-Step Instructions - Wickes 216-992 Installation Instructions Manual

Step-by-Step Installation Instructions for
Pivot / Bi-fold Door & Side Panel Combination Pack
(216-992 / 216-993 / 216-995 / 216-997 / 216-999)
The Pivot / Bi-Fold door can be installed as a right hand or left hand entry.

STEP-BY-STEP INSTRUCTIONS

1. Ensure that all parts listed on page 3 are included in the box and that you have the
necessary tools to hand (some parts such as screws may have more than the number
stated). Ensure that you have sufficient space and a clean, dry area for assembly.
2. Using the spirit level, ensure that the shower tray (or base of the shower) is level on all
sides.
3.
Once you have located the two fixing holes at the top and two at the bottom of each
frame. Apply a short piece of protective tape to the lip near the holes (this will protect the
lip surface when using a screwdriver). With your assistant holding both frames upright,
carefully put four 40mm screws through the fixing holes Fig.1, by hand, so the screw
heads are just below the frame lip but not fully home. Align the side panel at right angles
to the door panel, so the screws through the door frame line up with the holes in the side
panel Fig.2. Note: Snap both frames together and ensure they are at right angles to each
other or you will damage the holes in the frame panel when you tighten the screws.
With your assistant holding both frames together, carefully and evenly tighten all four
screws using a normal screwdriver. Important: Do not use a power driver as this will
damage the lip, which can be seen with the cover piece in place).
When fully tightened, remove the two pieces of protective tape from the lip but don't fit
jointed cover profile, this comes later.
1
4.
Push fit the 2 frame end channels onto the completed frame assembly (lip with screw slots
facing inwards) Fig.3 and with your assistant, centrally locate the complete assembly in the
desired position over the shower tray. Check horizontal and vertical alignments using the
spirit level.
5. Again, with your assistant holding this in place, mark the position of the screw slots in the
frame end channels, on the tiled wall, with the marker pen/pencil Fig.4.
Customer helpline number: 01604 633607
Version 5 - 06/11
Panels would need to be inverted to do this
2 3
4