Related Manuals for Hunter X-CORE XC-2
Summary of Contents for Hunter X-CORE XC-2
- Page 1 X-CORE ® QUICK START GUIDE X-Core Irrigation Controller Programming Guide SCAN for help https:/ /hunter.help/XCore...
-
Page 2: Table Of Contents
⑨ Odd/Even/Interval Days ③ Program Indicator ⑩ Active Water Day ④ Month Symbol ⑪ Non-Active Water Day ⑤ Run Time Symbol ⑫ Day of Week ⑥ Seasonal Adjust (%) ⑬ Rain Sensor Active/Bypass ⑦ Station Running ⑭ Day Symbol https://hunter.help/XCore... -
Page 3: Setting The Current Date And Time
Setup SETTING THE CURRENT DATE AND TIME SETTING A PROGRAM START TIME Turn the dial to the DATE/TIME position. Turn the dial to the START TIMES position. The current year will be flashing. Use the + and – buttons to Use the PRG button to select program (A, B, or C). -
Page 4: Setting Water Days
SEASONAL ADJUST from station to station manually. • Changes all run times by a percentage for local conditions. • Press + or – to change from 10% to 150% of original run times. https://hunter.help/XCore... -
Page 5: Test Program
Setup TEST PROGRAM SENSOR BYPASS Runs all stations for a test run time. Overrides sensor shutdown to allow watering. Press and hold PRG for three seconds. Move sensor BYPASS switch to BYPASS position. Station 1 appears. Press + or – to enter run time. Return switch to ACTIVE to allow sensor shutdown. -
Page 6: Troubleshooting
Remove jumper wire on SEN terminals. Set sensor switch to STOP IRRIGATION switch in BYPASS position. Active position. CONTROLLER SEEMS TO Too many START TIMES. One Start Time operates all stations in a program. Remove WATER CONTINUOUSLY unnecessary Start Times. https://hunter.help/XCore... -
Page 7: Hidden Features
Hidden Features Feature Where Found Description PROGRAMMABLE Hold – and turn to START TIMES. Sets individual stations to ignore sensor shutdowns. Select stations with SENSOR OVERRIDE ◄ or ►, (use +/–) to change to OFF to ignore sensor. CYCLE AND SOAK Hold + and turn to RUN TIMES. -
Page 8: Compliance Information
Changes or modifications not expressly approved by Hunter Industries could void the user’s authority to operate this device. If necessary, consult a representative of Hunter Industries Inc. or an experienced radio/television technician for additional suggestions. The following statement is applicable when irrigation controller is used with accessory...
Need help?
Do you have a question about the X-CORE XC-2 and is the answer not in the manual?
Questions and answers
after l put in run 1 2 3 4 then 2:220 shows up then runs times start again