Client Setup - Mimosa C5 Client Manual

Mimosa Client Help Content
Mimosa Clients

Client Setup

This overview is intended to assist the user with preliminary radio setup prior to deployment.
Notes :
Notes :
Internet access is required to access firmware and online help resources.
If the radio is connected to a DHCP server, the default IP addresses shown below will be different.
1. Download latest Firmware for your device.
2. Connect the PoE to the Radio.
3. Prepare your computer for use.
Connect an Ethernet cable between your computer and the PoE port labeled DATA.
Ensure that your computer's IP address is different from that of the radio (192.168.1.20), but in the same
network. The subnet mask should be the same for both devices (255.255.255.0). Consult operating system
documentation for instructions about how to change your computer's IP address.
4. Access the radio in a browser.
Open a browser and enter 192.168.1.20 in the address bar.
Enter a password that will be used to administer the device.
5. Install firmware image.
Select the firmware image from your computer downloaded in step 1 for upload. The radio will validate and
install the firmware, and then reboot.
6. Assign a friendly radio name.
Navigate to Preferences > General > Device Friendly Name to enter a meaningful radio name.
7. Configure the radio's IP address.
Navigate to Preferences > Management > Management IP to ensure the settings match your existing
network configuration.
After changing the radio's IP address adjust your computer's IP address to operate on the same network.
8. Set the link details.
Navigate to the Wireless > Link > Link Configuration panel to set a Link Friendly Name.
Enter the SSID of the AP to which the Client will connect.
Enter the Encryption Key (Passphrase) required for the SSID.
9. Choose operating frequencies.
Navigate to Wireless > Channel & Power > Channel & Power Settings.
Choose a desired Maximum Channel Width.
Set Tx Power to desired level.
Copyright © 2014 Mimosa
Client Setup
Page 32