Set_6: Lh100 Reset To Factory Defaults - Lenz Digital plus LH100 Information Sheet

72

12.2.6 SET_6: LH100 Reset to factory defaults

The "SYS-6" command can be used to reset the LH100 to factory
default.

A Reset operation causes the following settings to change
XpressNET address = 1
Function 'St'-key = STOP
language = German
contrast LCD = 2
bit edit = 1...8
To configure this setting go to the SET menu:
Press On the display you see
alternates with
blinks quickly
blinks slowly
Information LH100 V3.6
Explanation
The LH100 display alternates
between "RESET" and "LH100"
al
'Enter' confirms the desire to perform
a reset. Press 'Enter' a second time
to start a reset or 'Esc' to abort the
operation.
The reset operation starts with
"Reset" on the LH100 display. After
about 5 seconds the display goes
through several displays as it resets
When the reset is completed the
LH100 returns to locomotive
operation.