Sealey MES02 Instructions

thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
instruction
manual
1. safety
Warning! Ensure all Health and Safety, local authority, and general workshop practice regulations are strictly adhered to when using this
‰
equipment.
dO nOt use unit if damaged.
8
replace or repair damaged parts. Use recommended parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
Keep the stand clean for best and safest performance.
9
locate the stand in a suitable work area. Keep area clean and tidy and free from unrelated materials. ensure there is adequate lighting.
9
use on a firm, level surface capable of sustaining the stand and the load.
9
maintain correct balance and footing. ensure the floor is not slippery and wear non-slip shoes.
9
ensure all non-essential persons keep a safe distance whilst the stand is in use.
9
lock ratchet in position with locking pin before fixing a load and ensure the engine is centred and securely mounted.
9
ensure the stand and load are stable.
9
dO nOt allow untrained persons to use the stand.
9
dO nOt exceed the rated capacity of 75kg.
8
dO nOt use the stand for purposes other than those for which it is designed.
8
When not in use store stand in a safe, dry, childproof area.
9
2. intrOductiOn
suitable for a wide variety of engines and transmissions. features fully adjustable lower mounting arms and swivel castors, capable of supporting
larger (maximum 75kg) multi cylinder engines. supports can rotate for accessibility to all parts of the engine.
3. specificatiOn
model no: .................................................................. mes02
maximum capacity: ........................................................ 75kg
min./max. width engine mounting brackets: ........ 150-360mm
min./max. length: ................................................. 550/940mm
min./max. height: ................................................. 540/795mm
© Jack sealey limited
instructions for
engine rebuild stand - multicylinder
mes02
model no:
Original Language Version mes02| issue 1 15/03/16