Icom IC-208H Adjustment Procedure
Hide thumbs
Also See for IC-208H:
- Instruction manual (96 pages) ,
- Service manual (52 pages) ,
- Service manual (8 pages)
Related Manuals for Icom IC-208H
Summary of Contents for Icom IC-208H
- Page 7 IC-208H ADJUSTMENT PROCEDURES 1 PREPARATION When adjusting IC-208H, need to enter adjustment mode and the JIG cable is required. I REQUIRED TEST EQUIPMENT EQUIPMENT GREDE AND RANGE EQUIPMENT GREDE AND RANGE Output voltage : 13.8 V DC Frequency range : 0–600 MHz...
-
Page 8: Software Adjustment
2 SOFTWARE ADJUSTMENT ADJUSTMENT ADJUSTMENT CONDITION OPERATION REFERENCE • Operating frequency : 445.0 MHz • Turn the [DIAL] to set to 445.0000 MHz. • Loosely couple a frequency counter to the antenna • Push the [BAND] key. FREQUENCY [Fr] connector on the rear panel. •... -
Page 9: Adjustment Condition
SOFTWARE ADJUSTMENT-Continued ADJUSTMENT ADJUSTMENT CONDITION OPERATION FREQUENCY • Operating frequency : 144.0 MHz • Turn the [DIAL] to set to ±4.6 kHz. DEVIATION • Connect an audio generator to the [MIC] jack and set • Push the [BAND] key. (VHF band) : +20 dB [DE] •... - Page 10 SOFTWARE ADJUSTMENT-Continued ADJUSTMENT ADJUSTMENT CONDITION OPERATION TRACKING • Operating frequency : 400.1 MHz • Push the [BAND] key. (Middle2 • Connect an SSG to the antenna connector and set as band) Level : 1 µV* (–107 dBm) [Tr] Modulation : 1 kHz Deviation : ±...
- Page 11 SOFTWARE ADJUSTMENT-Continued ADJUSTMENT ADJUSTMENT CONDITION OPERATION SQUELCH • Operating frequency : 146.1 MHz • Push the [BAND] key. LEVEL • Connect an SSG to the antenna connector and set as (Wide) Level : 0.079 µV* (–129 dBm) [SqW] Modulation : 1 kHz Deviation : ±...
- Page 12 SOFTWARE ADJUSTMENT-Continued ADJUSTMENT ADJUSTMENT CONDITION OPERATION TEMP. • Operating frequency : 445.0 MHz •Turn the [DIAL] to set to “F9” on the display. • Receiving • Push the [BAND] key. CORRECTION <High power> (UHF –10˚C) [HP–] (UHF +60˚C) • Operating frequency : 445.0 MHz •Turn the [DIAL] to set to “07”...
Need help?
Do you have a question about the IC-208H and is the answer not in the manual?
Questions and answers