Removing The Hard Disk Drive/Hdd, X10; Replacing The Sal-1001 Board - Sony FMP-X10 Repair Manual

SECTION 2 - DISASSEMBLY/PART NUMBER INFORMATION

REMOVING THE HARD DISK DRIVE/HDD, X10

1. Locate the 2 connectors shown in the illustration.
2. Locate and disconnect the Harness (DH-1005).
3. Locate and disconnect the Harness (SHS-1001).
4. Locate and remove 4 screws from HDD Bracket, then lift to detach.
5. Place HDD, X10 facing down, remove 4 screws to detach from HDD
Bracket as shown.
FMP-X10
Harness, DH-1005 Harness, DH-1005
Harness, SHS-1001 Harness, SHS-1001
HDD, X10 HDD, X10
HDD, Bracket HDD, Bracket

REPLACING THE SAL-1001 BOARD

1. Locate and remove the 3 screws as shown in the illustration.
2. Locate all connectors on the SAL-1001 Board, then disconnect
the Fan connectors as shown.
3. Disconnect the LVDS Cable and the Wi-Fi Harness as shown from
the SAL-1001 Board.
4. Locate and remove 3 screws to lift and detach.
5. Install the new SAL-1001 Board, screws and connectors.
SAL-1001, Board SAL-1001, Board
13