Packet Filter Entry Setting - NEC ZA-SA3500G Function Manual

5.7.17. Packet Filter Entry Setting

Specify the target interface and set the passing or discarding of packets satisfying the specified condition.
*Note when IPsec 1 is selected for target interface
The target interface "IPsec 1" setting is enabled only when the VPN operation mode is set to route based in the IPsec
setting.
1. Open the [IPv4 Packet Filter] screen from [TOP]-[Maintenance]-[Filter Setup].
2. Select filtering point from "Select Target Interface". Select from "IPoE", "PPPoE", "LAN", or "IPsec 1".
3. Click "Edit" to go to the following screen.
4. Click the "Apply" button.
5. Click the "Save" button.
236 Setting/Setting Confirmation|