Aruba AP-505H Installation Manual page 2

Color/State
Green- flashing pattern 2
Amber- solid
Amber- flashing pattern 1
Red
1 Blinking: one second on/one second off, 2 second cycle.
2 Flashing Pattern 1: mostly on, briefly off, 2 second cycle.
3 Flashing Pattern 2: mostly off, briefly on, 2 second cycle.
Radio Status
The Radio Status LED indicates the operating mode of the access point's radios. See
Table 2 Radio Status LEDs
Color/State
Off
Green- solid
Green- blinking
Amber- solid
Amber- blinking
Green/Amber-
alternating
1 Alternating: one second each color, 2 second cycle.
LED Display Settings
The LEDs have three operating modes that can be selected in the system management software:
Default mode: Refer to

Off mode: LEDs are off

Blink mode: LEDs blink green

Force the LEDs into off mode and back to software defined mode by pressing the reset button for a short
duration. Warning: pressing the reset button for longer than 10 seconds may cause the AP to reset and return to
factory default state.
2
Meaning
Deep sleep mode
3
Device ready, restricted power mode (limited PoE power available, or IPM
restrictions applied), no network restrictions
Device ready, restricted power mode (limited PoE power available, or IPM
restrictions applied), uplink negotiated in sub-optimal speed (<1Gbps)
System error condition - Immediate attention required
Meaning
AP powered off, or both radios disabled
Both radios enabled in access mode
One radio enabled in access mode, other disabled
Both radios enabled in monitor mode
One radio enabled in monitor mode, other disabled
Green: one radio in access mode
1
Amber: one radio in monitor mode
Table 1 and Table 2
Table 2.
Aruba AP-505H Access Points | Installation Guide