Installing And Wiring The Drive Unit; Installing The Drive Unit; Drive Unit Wiring Diagram - Shimano Steps E6000 Series Dealer's Manual

Installing and wiring the drive unit

Installing the drive unit

Installing and wiring the drive unit
„ Installing the drive unit
Align the three mounting holes (B) in the
drive unit (A) with those in the frame.
1
Insert M8 bolts, attach nuts from the
opposite side, and tighten them to the
designated torque.
2
„ Drive unit wiring diagram
Below is an example of wiring on a carrier type battery.
(B)
(A)
21
(A)
Drive Unit
(B)
Mounting holes
Bolts and nuts are not included with Shimano
products. Use those supplied by the
manufacturer. For information on the
tightening torques, contact the manufacturer.
(A)
Light connector
(B)
Speed sensor connector
(C)
E-tube connector for cycle
computers and motor units
(D)
Ferrite core
Be sure to attach dummy plugs to any unused
ports.
•
The left illustration shows an example of
wiring.
(D)
(A)
(B)
(C)
•
The light connector can be used through
both ports (A).
•
The E-tube connector for cycle computers
and motor units can be used through both
ports (C).
NOTE