Installing And Removing The Cycle Computer; Adjusting The Angle Of The Cycle Computer - Shimano Steps E6000 Series Dealer's Manual

Installation

Installing and removing the cycle computer

„ Installing and removing the cycle computer
Slide the cycle computer (A) into the
bracket (B) as shown in the illustration.
Insert it firmly until you hear it click.
1
To remove the cycle computer, slide it
while pushing the bracket lever (C).
2
„ Adjusting the angle of the cycle computer
Loosen the angle adjustment screw (A) with a
screwdriver. Adjust the angle of the cycle
computer to make it easier to see while riding.
After determining the angle, tighten the screw
to the designated torque.
(B)
(C)
(A)
13
(A)
Cycle computer
(B)
Bracket
(A)
(C)
Lever
If the cycle computer is not in the correct
place, the assist function will not operate
normally.
(A)
Angle adjustment screw
Tightening torque:
0.5 N·m
{4.4 in. lbs.}
NOTE