HP 9000 Manual page 51

If you selected "Install HP-UX" in the "Welcome" screen, you will see the
Select Media or
Network Installation
following:
Figure 3-11
===========================================================================
This screen lets you pick from options that will determine if an
Ignite-UX server is used, and your user interface preference.
Source Location Options:
[ * ] Media only installation
[ ] Media with Network enabled (allows use of SD depots)
[ ] Ignite-UX server based installation
User Interface Options:
[ * ] Guided Installation
[ ] Advanced Installation (recommended for disk and filesystem management)
[ ] Remote graphical interface running on the Ignite-UX server
Hint: If you need to make LVM size changes, or want to set the
final networking parameters during the install, you will
need to use the Advanced mode (or remote graphical interface).
[ OK ]
================================================================================
• Select the Source-Location of installation, by typing an "*" in the box.
• Select among the User Interface options to designate where you
NOTE If you only wish to access an SD depot over the network, then you should
choose Media with Network enabled.... You will then be able to specify
the SD depot later during the media install.
The third selection requiring a network server be configured and
available.
Chapter 3
User Interface and Media Options
(recommended for basic installs)
[ Cancel ]
intend to control the installation from. A Remote graphical interface
assumes that you have an Ignite-UX server configured and available.
• Select Guided Installation. This has the following characteristics:
• Instructions for each procedure.
• "Mainstream" configuration.
Installing From Media
Booting the Target System
[ Help ]
51