5
If the window is no present, remove the USB Drive and try reinserting the USB Drive again.
6
Start the software upgrade by using the "left or right arrow" key of the remote control to select "Yes".
7
Press "OK" key of the remote control to begin the upgrade.
8
The software upgrading process will begin. During the
"Updating... don't AC power off" as shown in Figure4.
During this time, do not remove power to the television or press an
o
n the television unti
9
Upon completion of the sof
1
0
Remove the "USB Drive" from the slot.
1
1
The TV will turn OFF and then, turn ON automatically.
1
2
Perform the "Initial Setup" and set "Personal Preference" of the
Refer to your Owner's manual should you have any questions.
Copyright 2010
l the upgrade is complete!
tware upgrade a message will appear as shown in Figure5.
software upgrade, the TV receiver will display
Figure4
Figure5
All Rights Reserved
y remote keys or buttons
TV.
Page 2 of 2