General Instructions On Material Damage And Product Damage - Bosch Rexroth Hägglunds CA Series Manual

3 General instructions on material damage
RE 15440-X-B2/11.2016, Product specific Intallation and maintenance manual Hägglunds motors, Bosch Rexroth Mellansel AB

General instructions on material damage and product damage

and product damage
Danger from improper handling!
Product can be damaged!
▶ Do not expose the product to an impermissible mechanical load.
▶ Never use the product as a handle or step.
▶ Do not place/lay any objects on the product.
▶ Do not strike the Hägglunds motor or any part of it or its accessories.
▶ Do not set/place the Hägglunds motor on the drive shaft or fittings.
▶ Do not strike fittings (e.g. sensors or valves).
▶ Do not strike sealing surfaces (e.g. service line ports).
▶ Leave the protective covers on the Hägglunds motor until shortly before the lines
are connected.
▶ Do not perform electro-welding on the Hägglunds motor.
Damage to equipment due to improper lubrication!
Product can be damaged or destroyed!
▶ Never operate the Hägglunds motor with insufficient hydraulic fluid.
▶ When commissioning a machine/system, make sure that the case interior and
the service lines of the Hägglunds motor are filled with hydraulic fluid and
remain filled during operation.
▶ Check the hydraulic fluid level in the case interior regularly; if necessary,
recommission. With above-reservoir installation, the case interior may drain via
the reservoir line after longer standstill periods (air enters via the shaft seal) or
via the service line (gap leakage). The bearings are thus insufficiently lubricated
at switch on.
Mixing of hydraulic fluids!
Product can be damaged!
▶ Before installation, remove all fluids from the Hägglunds motor to prevent mixing
with the hydraulic fluid used in the machine/system.
▶ Any mixing of hydraulic fluids of different manufacturers or different types of the
same manufacturer is not permissible in general.
NOTice
11/20