Panasonic EH-HS60 Operating Instructions Manual page 4

Parts identificatio n
Shaded areas represent heated sections. To avoid burns, do not
touch these parts w hen the hair straightener is turned on.
© Switch
© Grip
@ P ress plate
Iron plate (inside of the press
plate)
© S team outlet
© Negative ion nozzles
© Lamp
Iro n plate
S w itc h
2 Heats up
1 Heats up
O LO C K The power turns off and the iron plate closes.
4
G
Iron plate (inside o f the main
body)
Tank
Buttons
© Tank block
A Felt
© Cap
© Plug
Iro n plate
N e g a tiv e io n s
h
Heats up Released
- Released
Filling th e ta n k w ith w a te r__________________________
1 Pull th e ta n k straig h t out in a slig h tly upward
d irec tio n , w h ile pressing buttons on both sides
o f th e tank.
2 O pen th e plug o f th e ta n k and
s o ak th e felt p art insid e o f th e
ca p (ab o u t 5-6 seco n ds).
• The hair straightener may have difficulty
releasing steam if the felt is dry. In this
case, thoroughly soak the felt
(approxim ately 10 minutes) before use.
3 Fill th e tan k w ith w ater, and then secu rely
attach th e plug.
• Use only tap water. (Use of other types of w ater may dam age the
hair straightener.)
• Be sure not to let dirt get between the plug and tank. (D irt may
cause w ater leakage.) W ipe off excess w ater before attaching
the tank. (Excess w ater may cause hot w ater droplets to be
generated.)
4 A lign th e ta n k w ith th e end o f th e hair
s tra ig h te n e r and attach it fro m above.
5
Push th e ta n k in until a click is heard.
• N otes
• Note that the surface of the hair straightener becomes hot if
used w ithout water.
• The hair straightener can be used for approxim ately 10 minutes
on a full tank of water.
• Before attaching the tank to the hair straightener, be sure to
shake the hair straightener 2-3 tim es with the open (tank) end
facing down to drain out any water. Hot w ater droplets may be
discharged if w ater remains in the hair straightener.