Installation - Kenwood KVT-925DVD Instruction Manual

Installation

Installation for Monitor/Player Unit
Firewall or metal support
Screw (M4X8)
(commercially available)
Self-tapping screw
(commercially available)
Metal mounting strap
(commercially available)
Make sure that the unit is installed securely in place. If the unit is
unstable, it may malfunction (eg, the sound may skip).
Installation for Receiver unit
1. Attach the installation brackets 0 to the sides of the
hideaway unit using the sems bolts 8.
2. Use the tapping screw 9 to secure the hideaway unit to the
audio board.
100 English
Bend the tabs of the mounting sleeve
with a screwdriver or similar utensil
and attach it in place.
Accessory 6
Sems bolts (M4 × 8 mm)
(Accessory 8)
Installation brackets
(Accessory 0)
Tapping screw (ø4 × 16 mm)
(Accessory 9)
Installing the Antenna Units
¶
Attach the antenna to the inner glass surface of the rear window using double-sided tape. Carefully check the
installation location as the tape can only be stuck on once.
¶
If the surface temperature of the glass of the rear window is low, warm it by turning on the power of the rear
defogger.
A cold window glass surface will weaken the adhesive strength of the double-sided tape.
Also, if installation inside the cabin is performed on a day with high humidity or when it is raining, the high humidity
level will weaken the adhesive strength of the double-sided tape.
¶
Do not install the antenna in a location where it may obstruct the field of view during driving, such as on the
windshield.
1. Check the location where the antenna - is to be
attached. Clean off any grease or dirt from the
installation location using the supplied glass cleaner !,
clean the area with water and allow to dry.
Clean the glass thoroughly as failure to clean the glass
can not only weaken the adhesive strength of the double-
sided tape, but may also cause it to come loose.
2. Remove the protective strips from the antenna parts and
the back of the antenna unit.
3. Attach the double-sided tape of the antenna parts and
the antenna unit to the rear windshield glass. Attach the
double-sided tape by firmly pressing down from the top.
Secure cables using the supplied clampers =.
4. After attaching the antenna with the double-sided tape,
allow it to sit undisturbed for 24 hours. Take care not to
apply force to the antenna or allow it to get wet during
this time.
5. Connect the antenna cable to receiver unit.
Antenna parts
Antenna unit
Bundle cables with the
Rear window
clamper bar
Accessory @
Rear seat
English 101