®
R&S
ZNA
Restart Sweep
Stops the current measurement cycle and starts a new one.
For the DEFAULT
sweep modes
Manager
Active channel in "Continuous"
sweep mode
Active channel in "Single"
sweep mode
For remote languages other than DEFAULT, the effect of the "Restart Sweep" com-
mand is determined by the selected (common) sweep mode and restart behavior:
All channels in "Continuous"
sweep mode
All channels in "Single" sweep
mode
Remote command:
INITiate<Ch>[:IMMediate][:DUMMy]
INITiate[:IMMediate]:ALL
Restart Manager...
Opens the
All Channels Continuous/All Channels on Hold
Selects a common
●
"All Channels Continuous": all channels are set to "Continuous" sweep mode
●
"All Channels on Hold": all channels are set to "Single" sweep mode.
Restart Sweep
These actions are only available for the DEFAULT
remote languages, the
Channels Continuous"/"All Channels on Hold" buttons are greyed out;
Remote command:
INITiate:CONTinuous:ALL
User Manual 1178.6462.02 ─ 15
Remote
Language, the effect of this command depends on the
of the active channel, and the restart behavior defined in the
Dialog:
"Sweep Active Channel"
The "Continuous" sweep mode
channels are swept cyclically, the
"Single" sweep channels are on
hold.
First the active channel is swept
with its channel-specific number
of Sweeps. Then the "Continu-
ous" sweep mode channels are
sweep cyclically.
"Sweep Active Channel"
The channels are swept cyclically
The active channel is swept
Sweeps
are on hold
Restart Manager
Dialog.
sweep mode
initiates a new measurement cycle.
Continuous / Single
times. All other channels
for all channels of the active recall set.
Remote
setting applies to all channels and the "All
GUI Reference
Sweep Softtool
Restart
"Sweep All Channels"
First the "Single" sweep mode
channels are swept one after the
other, each with its channel-spe-
cific number of Sweeps. Then the
"Continuous" sweep mode chan-
nels are sweep cyclically.
"Sweep All Channels"
The channels are swept one after
the other, each of them
Sweeps
times.
Language). For other
475
Need help?
Do you have a question about the ZNA Series and is the answer not in the manual?
Questions and answers