Unpairing Bulbs / Resetting Bulbs To Factory Defaults - Lutron Electronics Aurora Z3-1BRL Advanced Installation Manual

Aurora

Unpairing Bulbs / Resetting Bulbs to Factory Defaults

Follow the instructions below to erase all of a bulb's pairings (to
remotes and/or a hub) and reset it to the "factory default" state.
1
Turn power to the light OFF and then back ON
NOTE: Power must be removed and then re-applied to bulb by
toggling the wall switch, by turning the lamp switch OFF and then
ON, or by unscrewing and then re-screwing in the lamp (being
careful to make sure it's not hot).
NOTE: This allows the lights to connect with controls for about
15 minutes.
Hold the Aurora dimmer as close as possible to
2
the bulb
<4 in (10 cm)
3
Tap button quickly 3x
3x
On the third tap, continue holding button for a long
4
time (19 seconds total)
16 sec
6
<4 in (10 cm)
The Aurora LED will "slow-flash" during this hold time – keep
a
holding the button.
After about 16 seconds of holding, the light should flash to
b
indicate which one you are selecting. If this is the correct
light, KEEP HOLDING the button. If it is not the correct light,
release the button and start again from Step 2.
After about 3 seconds of additional holding, the LED on
c
Aurora should start to rapidly flash – once this happens, the
bulb has been reset to factory defaults and you can release
the button. If the Aurora LED doesn't rapidly flash, but
instead simply stops flashing, then release the button and try
the procedure again from Step 2.
15
+3 sec
3