Huawei N5368X Quick Start

5G Outdoor CPE N5368X
Quick Start
Part Number: 31071318
Version: Draft C
1
Tools
Before installing the CPE, verify that you have all the items listed in the packing list. If any of the
items is missing or damaged, contact your device provider.
1 x Outdoor-oriented mounting
bracket (including bolts)
1 x N5368X 2 x Hose clamp
You need to prepare the following tools and auxiliary materials:
Adjustable
M6 hex key Screwdriver
wrench
2
Hardware Introduction
WiFi
5G
4G
1 x Indoor fixed-length
Ethernet cable
1 x Indoor-oriented
mounting bracket
1 x Waterproof
PG connector 1 x Quick Start
Rubber Hammer
Ethernet cable
mallet drill
RST Nano SIM LAN WiFi Power/LAN
Running Status/Factory Reset Indication
The WiFi indicator, 5G indicator, and 4G indicators are on and off simultaneously.
Color
Status
WiFi 5G 4G
Green Green Green Steady on
Blinking thrice (on for
Green Green Green
0.5s and off for 0.5s)
Blinking at 0.5 Hz (on
Yellow Yellow Yellow
for 1s and off for 1s)
Red Red Red Steady on
Gray Gray Gray Off
Upgrade Status Indication
Color
Status Description
5G 4G
The device is restarted for an upgrade to load the new
Green Green Steady on
version. The process is expected to take about 5 minutes.
· Before an upgrade (normal version verification and
Blinking(on for 0.2s
Green Green decompression; upgrade in progress)
and off for 0.2s)
· After an upgrade (version verification)
When the upgrade is successful, the indicator blinks green
Blinking (on for 1s
Green Green slowly thrice, and then the device starts up and enters the
and off for 1s)
network searching state.
Red Red Steady on The upgrade fails.
LAN Port Status Indication
Color
Status
5G
4G
Blinking at 2 Hz
Red Red
(on for 0.25s and off for 0.25s)
SIM Card Slot Status Indication
Color
Status
5G 4G
Blinking at 0.5 Hz
Red Red
(on for 1s and off for 1s)
Description
· The device is powered on and starting up.
· The device is running properly. The hardware is
normal, and there is no software alarm.
The device is about to restore the factory settings and
restart.
The hardware component is normal and the network
searching state starts.
An exception in hardware component is detected.
The power is off or software configuration is disabled.
If the Wi-Fi hardware switch is turned off, the WiFi
indicator is off.
Description
The LAN port is not connected.
Description
The SIM card is not properly installed or is faulty.