SunSetter Motorized Replacement Instructions page 2

Note: The threaded holes on the replacement
Motor Plate are marked to indicate the holes to
use during reassembly. Align these holes with
the holes noted or marked on the Roller Bracket,
in Step 5.
9. Replace the Roller Bar between the two Roller
Brackets.
Note: Ensure the Gray Bushing is on the Round
Pin of the End Cap before sliding it into the
Roller Bracket (on the end opposite the Motor).
Ensure the End Cap
of the Roller Bar is in
contact with the Roller
Bracket on the end
opposite the Motor.
See Figure 5.
10. Slide the Roller Bracket, if loosened in Step 7,
up against the Motor End Plate, for a snug fit.
11. Attach the Motor to the Roller Bracket with
the two ¼-20 hex bolts and washers. See Figure 3.
Note: Be very careful not to cross-thread the
hex bolts; start the bolts by hand and finish
tightening them with the 7/16" wrench. Using a
13 mm or ½" wrench, tighten the bolt on the
Roller Bracket.
12. Remove the Override Crank from your
old Motor using a 3 mm Allen wrench. Insert
the Override Crank into the new Motor from
the bottom of the groove in the Motor so the
Override Crank loop faces downward. Secure the
Override Crank from the top with the Allen Cap
Bolt and Washer. See Figure 6.
Override
Crank
Figure 6
Figure 5
End Cap on
Round
Roller Bar
Pin on
End Cap
3 mm Allen Wrench
Allen Cap Bolt and Washer
Motor
Note:
• For LEFT side Motor, the Override Crank
should be facing toward the Front of the
Awning and the Motor Cord should be facing
up. See Figure 7.
• For RIGHT side Motor, the Override Crank
should be facing toward the Front of the
Awning and the Motor Cord should be facing
toward the ground. See Figure 8.
Power Cord Faces Up
Left Side
Mounted
Motor
Figure 7
13. Center the Fabric on the Roller Bar and on the
Front Bar. Hold the Fabric snug across the length
of the Roller Bar, ensuring it rolls up evenly.
14. Use the Manual Crank Wand to slowly roll
the Fabric onto the Roller Bar, until the Awning is
approximately half-way closed.
15. Reinstall the Hood End Plate if removed.
16. Plug the Power Cord back into the wall outlet.
17. To program the new Motor to your existing
Remote Transmitter and set the new Closed and
Open stops for your Awning, go to Appendix A.
18. Test the Awning for proper operation.
19. Add Additional Control Devices:
• To add another Remote Transmitter or an
All Weather Remote Transmitter, go to the
section titled "To Add an Additional Control
Device" located at the end of Appendix A.
• To add a Wireless Wind Sensor or Wireless
Wall Switch, go to Page 4.
Note: If the old Motor needs to be returned to
SunSetter Products, please find a PrePaid UPS
Return Label attached to the shipping tube of
the replacement Motor.
2
Figure 8
Right Side
Mounted
Motor
Power Cord Faces Down