Ups Connections; Terminal Block - 208/240; Out - Toshiba 1600XPi Series Installation And Operation Manual

7

UPS Connections

7.1 Terminal Block - 208/240 V
The following illustration is a detail view of the terminal block and wiring connections used for 208/240 volt units (see
"Appendix C: 1600XPi Dimensions and Weights" on page C1).
1 2
L1 (L*) L2 (N*)
208/240 V
in
INPUT
* – If only one input line is hot, connect hot line to terminal 1 (L), and connect the Neutral line to terminal 2 (N).
NOTE 1 – If AC input power is 208 Vac rated, short terminals 11 and 12 with a jumper wire. DO NOT jumper terminal 13 to 12 or 11. Factory Setting is
208 Vac. Use the jumper wire provided by Toshiba. DO NOT add any additional jumpers.
NOTE 2 – If AC input power is 240 Vac rated, short terminals 12 and 13 with a jumper wire. DO NOT jumper terminal 11 to 12 or 13. Use the jumper
wire provided by Toshiba. DO NOT add any additional jumpers.
NOTE 3 – EPO and Rmt Contacts function – See Section 8.2
12
, 120/208/240 V
IN
Factory Installed N - G Jumper
3 4 5 6
G X1 X2
N (0V)
32 V 88 V
120 V 120 V
208 V
240 V
OUTPUT

OUT

1,2
12
7 8 11
X3 G 208 COM 240
208V 240V
Jumper selection
See notes 1&2
1600XPi Series UPS Installation and Operation Manual – 60616-014
13 14 15 16
EPO1 EPO2
REMOTE1
NO NO
EPO
Rmt Contacts
3
17
REMOTE2
3