Components; Grill Heating Element; Turbo Motor; Rotisserie Motor - Blomberg BWOS 24102 SS Service Manual

Chapter 1/Components
Chapter 1/Components

Grill heating element

It is the heating element which
is activated by the control knob
and used for grilling in electirical and
multi-functional ranges. It is controlled by the thermostat
and the commutator under the control knob and
provides heat to the oven from the oven body upper
part.
Oven heating element
It is the heating element which is controlled
by the commutator under the control knob
and providing the possibility of cooking
food inside the oven body at desired
temperatures with the assistance of the electrical
thermostat in electrical and multi-functional ranges. It
is located under the oven body, between the oven
body and oven bottom support sheet.
Turbo heating element
It is the heating element located on the
oven body rear wall in turbo and multi-
functional ranges. The air is sucked
through the holes with the assistance of
the suction holes found on this surface, and blowed
out from the air holes which are located next to the
suction holes. The heated air performs the cooking
operation passing through the upper and lower tray
surfaces. The turbo heating element and the fan are
controlled with the oven control knob located on the
control panel.
Electrical thermostat
It is the electrical component that adjusts
the heating elements to the desired
operating temperature when the releated
contol knob is turned on.
BARBAROS BUILT IN OVEN

Turbo motor

It operates alone itself at defrost
position in turbo and multi-functional
ranges. At the positions it operates
together with the turbo heating
element, it provides that the heat on
the turbo heating element is uniformly spreaded into
the oven body with the assistance of the turbo motor
fan.

Rotisserie motor

It operates together with the grill heating element
at grill position in electri cal and
multi-functional ranges, whereas it
is controlled by a separate knob at
gas ranges. The rotisserie function
can be performed by attaching the
turn spit bed into the rotisserie motor. The motor
operates with 4 W power and 2 rpm stroke.
Terminal block
It is the connection element where the supply cord
and the cables inside the oven are
attached to. The cables which are
connected to the components inside the oven are
distributed from the terminal block.
Oven lamp
It is controlled by the commutator connected to the
control knob and illuminates the inside of
the oven body.
Mechanical timer
Mechanicaal timer is used for setting cooking time.It
will ring after the end of the time set.
Page 4