Cub Cadet 19A70040100 Operator's Manual page 12

Assembling the Discharge Chute Components
1. Insert the inner boot bracket into the chute elbow as
shown in Figure 4-15.
2. Install the discharge chute top mounting bracket onto the
topside of the discharge chute using five (5) 710-0751 hex
bolts, as shown in Figure 4-15, and securing with three (3)
736-0270 bevel washers and five (5) 712-3027 flange lock
nuts, all included in hardware pack 689-00337.
Note: The bolt at each end of the discharge chute top
mounting bracket also routes through the inner boot
bracket below. Be sure to secure this inner boot bracket
when installing the hardware in Step 2. No bevel washers
are needed for the screws that secure the two brackets
together.
3. Install the chute support bracket into the center two holes
of the top mounting bracket, as shown in Figure 4-15, using
two (2) 710-3015 hex bolts and securing with two (2) 736-
0270 bevel washers and two (2) 712-3027 flange lock nuts,
all included in hardware pack 689-00337. Be sure to mount
the bracket with the raised tab facing the tractor, as shown.
4. Install the (1) 735-0199A rubber bumper, from hardware
pack 689-00340, into the hole provided on the chute
support bracket, as shown in the inset of Figure 4-15.
The bumper should be orientated towards the tractor, as
shown.
5. Install the boot strap, 723-0476, from hardware pack 689-
00340, with the metal wire ends, onto the discharge chute
elbow using a 711-04069 deck pin and 736-3092 flat washer
from the same hardware pack (689-00340) Secure the strap
using a 712-3027 lock nut from hardware pack 689-00337.
See Figure 4-16.
12 S 4 — A
ection SSembly
Figure 4-15
& i
nStAllAtion
Figure 4-16
NOTE: Check the upper chute for a cardboard insert
installed for shipping purposes. If the insert is present,
remove it before continuing.
6. Locate the upper chute tube and install the 723-04009A
chute strap included in hardware pack 689-00340, to the
upper chute tube using a 710-0924 machine screw and
712-04064 flange nut provided In hardware pack 689-
00337. See Figure 4-17.
Figure 4-17
7. Peel the backing off of the self-adhesive foam strip (721-
04388) that has been included with your grass collector.
Apply it to the upper chute, flush against the flange as
shown in Figure 4-18.