Cub Cadet 19A70040100 Operator's Manual page 11

15. Open the bagger cover by pushing in on the rear, right-side
tab with your right hand, as seen in 1 of Figure 4-12, and
lifting the cover with your left hand in the center rear of the
bagger cover, 2.
2
Figure 4-12
16. Install the bag assemblies onto the bag support brackets
by inserting the front edge in first, as seen in Figure
4-13, and setting the back edge down until it fits into the
assembly.
1
Figure 4-13
1
2
Installing the Deck Baffle
Note: Installing the deck baffle may be easiest with the deck
removed as instructed in the tractor's operator's manual, however
it is not mandatory. The baffle may be installed with the deck still
mounted on the tractor, raised to its highest cutting position, but it
will be somewhat more tedious.
Note: This bagging kit is designed to fit three different
deck sizes, therefore three different deck baffles have been
included in this kit. Be sure to select the proper deck baffle for
the deck size this bagger is being installed on.
1. Locate the two baffle mounting brackets included in
hardware pack 689-00340, and position the brackets
INSIDE of the deck, lining up the two holes on the front of
the deck as shown in Figure 4-14
2. Secure the brackets to the deck using four 710-0514
hex screws, included in hardware pack 689-00340, fed
through the front of the deck and threaded into the bagger
mounting brackets.
Note: It is recommended to leave all of the hardware in Steps
2 and 3 only finger tight until all six screws are started. Then
tighten all of the 6 screws installed in Steps 2 and 3.
3. Align the proper sized baffle with the holes in the bottom
of the baffle mounting bracket and secure with two 710-
04095 hex screws included in hardware pack 689-00340.
Note: There are three different baffles included with this
bagging kit, each is for a different sized deck. Using the
parts list later in this manual, identify the proper deck
baffle for the deck this bagger is being installed on. Also
use the part list for the proper orientation of the deck
baffle. Basically, the 48" and 60" deck baffles mount with
the widest end towards the discharge chute, and the 54"
deck baffle mounts with the narrow end towards the
discharge chute.
Figure 4-14
S
ection
4 — A & i
SSembly nStAllAtion
11