Maintenance Instructions; Storage Instructions - Craftsman CMXCESM14143 Instruction Manual

7.2 CHARGING A MOBILE DEVICE, USING THE USB PORTS
The CMXCESM14143 includes two USB ports. One provides up to
2.4A at 5V DC; the other provides up to 1A at 5V DC.
1. For best results, use only the cable approved by your mobile device
manufacturer. Consult your mobile device manufacturer for proper
charging power specifications. Connect a mobile device cable to the
appropriate USB port.
2. Slide the ON/OFF switch to the ON position. Charging should begin
automatically.
3. Charging time will vary, based on the mobile device's battery size and the
charging port used. NOTE: Most devices will charge with either USB
port, but may charge at a slower rate.
4. When finished using the USB port, disconnect the charging cable from
your mobile device and then disconnect the charging cable from the unit.
Slide the ON/OFF switch to the OFF position.
5. Recharge the unit as soon as possible after each use.
NOTE: If no USB device is connected, power to the USB ports will
automatically shut off after 30 seconds.
7.3 USING THE LED LIGHT
1. Slide the ON/OFF switch to the ON position.
2. Hold down the
3. Once the LED light is on, press and release the
through the following modes:
• Steady glow
• Flash for an SOS signal
• Flash in strobe mode
4. When finished using the LED light, press and hold the
the light turns off.
5. Slide the ON/OFF switch to the OFF position.
6. Recharge the unit as soon as possible after each use.

8. MAINTENANCE INSTRUCTIONS

8.1 After use and before performing maintenance, unplug and disconnect
the unit.
8.2 Use a dry cloth to wipe all battery corrosion and other dirt or oil from
the battery clamps, cords, and the outer case.
8.3 Do not open the unit, as there are no user-serviceable parts.

9. STORAGE INSTRUCTIONS

9.1 Charge battery to full capacity before storage.
9.2 Store this unit at temperatures between - 4°F- + 140°F ( - 20°C- + 60°C).
9.3 Never completely discharge the battery.
9.4 Charge after each use.
9.5 Charge at least once every month, if not in frequent use, to prevent
over-discharge.
button for 3 seconds.
• 9 •
ENGLISH
button to cycle
button until