Troubleshooting - Craftsman CMXCESM14143 Instruction Manual

ENGLISH

10. TROUBLESHOOTING

Jump Starter
PROBLEM
The jump starter turns on, but
won't jump start my vehicle.
The jump starter will not
recharge.
All four LEDs flash.
The last LED flashes, then
turns off.
When cable is correctly
connected to both battery
and jump starter: Green LED
blinking; Red LED off; no beep.
Smart Cable LED and Alarm Behavior
BEHAVIOR
Green LED blinking; Red LED
off; no beep.
Green LED solid; Red LED off;
no beep.
Solid Red LED, Green LED off;
beeps once per second
Solid Red LED, Green LED off;
beeps twice per second
Alternating Red and Green
flashing LEDs; no beep
Solid Red LED, Green LED off;
rapid beeping
Solid Red and Green LEDs;
no beep.
Solid Red and Green LEDs;
beeps once per second
NOTE: When the condition is corrected, the smart cable will automatically reset.
REASON/SOLUTION
Make sure the unit is charged.
Verify the charge level of the jump starter is
at least 50%.
Do not attempt to jump start your vehicle
more than three consecutive times. If
the vehicle still does not start, consult a
qualified service technician.
Make sure the power source is live.
Low or high temperature. LEDs will stop
flashing when the condition is corrected.
Over-discharge. Recharge the internal
battery.
"Fake" high battery voltage is detected, but
reverse charging protection did not activate.
User can turn key to jump start the vehicle.
Cable is connected to jump starter only.
Cable is connected correctly to both
battery and jump starter.
Low voltage protection
Reverse polarity protection
Reverse charging protection
Short circuit protection
Auto shut-off, due to inactivity. Disconnect
and reconnect clamps to the vehicle battery.
Temperature protection
• 10 •
REASON