Zmorph FAB Quick Start Manual page 46

Help and support
Calibration result
inaccurate.
Config file does not
exist.
Config file corrupted.
In case of inappropriate machine behavior, take every precaution and disconnect the machine from the
power source and immediately contact with Technical Support:
support.zmorph3d.com/hc/en-us/requests/new
46
▪ Inaccurate result of
the auto calibration.
▪ Config file is missing.
▪ No reading from
internal SD Card.
▪ Internal uSD Card
is unplugged or
damaged.
▪ Config file is
corrupted.
▪ Check if the work table is aligned correctly.
▪ Check if the X-axis is leveled correctly.
▪ Check the position of the Z-axis sensor.
▪ Restore the machine to factory default.
▪ Contact with Technical Support
▪ Check the uSD Card content.
▪ Check the uSD Card connection to mainboard.
▪ Visit knowledge base to download new config file.
▪ Contact with Technical Support.
▪ Visit knowledge base to download new config file.
▪ Contact with Technical Support.
Zmorph Fab - QUICK START GUIDE