Chassis (Main) Block-1 - Sony HCD-SBT100 Service Manual

HCD-SBT100/SBT100B/SBT300W/SBT300WB

2-12. CHASSIS (MAIN) BLOCK-1

Note 1: CN3002 and CN507 are quantity of pins of the same.
Do not insert to the wrong connector absolutely.
There is a possibility that the unit may be damaged if the wrong.
Wire e i
RELAY board
lead pin
MAIN
board
4 connector
(CN3002)
5 connector
(CN905)
– e r ie –
1 Remove wires from
the lead pin.
Note 2: Do not remove this connector (CN501)
at this point.
It is necessary to process electrostatic
measures of optical pick-up.
16
3 connector
(CN831)
2 flexible flat cable (5P)
(CN502)
CN507
6 Remove the
wire from the
coating clip.
7 connector
(CN304)
(SBT100/SBT300W)
8 flexible flat cable (9P)
(CN251)
(SBT100B/SBT300WB)
8 flexible flat cable (9P)
(CN104)
Wire e i
coating clip
OK
MAIN board
Note 3: Wire must not be extends
from the edge of the chassis.
Note 4: When you install the connector, please
install them correctly.
There is a possibility that this machine
damages when not correctly installing it.
OK
Insert is straight
to the interior.
connector
connector
NG
Insert is shallow
connector
connector
connector
Note 5: When installing the flexible flat cable,
ensure the colored line.
No slanting after insertion.
OK
Inserting is straight to the interior.
flexible flat cable
colored line
connector
NG
Inserting is slant.
flexible flat cable
colored line
connector
NG
NG
Insert is incline
connector