Removing And Installing Defroster Flap Control Motor V107 - Volkswagen Passat 2011 Workshop Manual

– Disconnect connector from temperature flap control motor -
V68- -1-.
– Remove bolts -arrows- (1.5 Nm).
– Release control motor lever from connecting rod.
– Remove temperature flap control motor - V68- . Pull heat ex‐
changer -2- cover forwards slightly when doing this.
Installing
– Observe notes ⇒ page 6
Note
Risk of malfunction of heater or air conditioning system caused
♦
by improperly installed control motors or links.
Mark the correct allocation of the connectors to the control
♦
motors.
Always install the appropriate links to the control motors.
♦
– Install temperature flap control motor - V68- in reverse order
of removal.
Note
After installing temperature flap control motor - V68- , check
♦
operation of temperature flap.
Initiate "Basic setting" function using vehicle diagnostic tester .
♦
Checking: vehicle diagnostic tester
♦
4.3 Removing and installing defroster flap
control motor - V107-
With potentiometer for defroster flap control motor - G135-
Special tools and workshop equipment required
♦ Vehicle diagnostic tester
Note
As of week 45/2013, control motors have been changed grad‐
♦
ually. Comply with the notes
⇒ "3.4 Notes on control motors", page 6
Electronic parts catalogue .
The colour-marked links which were factory-fitted and provi‐
♦
ded as replacement parts earlier have been discontinued
gradually as of week 45/2013. In addition, the links are not any
longer pre-installed on the control motors provided as replace‐
ment parts.
There are various available versions of control motors and the
♦
corresponding links. In some cases there are very slight dif‐
ferences which may not be obvious at first glance. However,
if the wrong version of a control motor or link is installed, prob‐
lems may occur not before the basic setting is performed.
.
, and refer to the ⇒
Passat 2011 ➤ , Passat Variant 2011 ➤
Heating, air conditioner - Edition 06.2017
51
4. Control motors